Pool Extension Assignment (#314)—Release 2.0 or
Later
5-219
4. At this point:
â– If you want to assign the pool to the first available button with lights,
press
D until a display similar to the following appears:
Pool Ext Assign 15 P881
1 Assigned
â– If you want to remove a pool assignment, press D until a
display similar to the following appears:
Pool Ext Assign 15 P881
2 Not Assigned
â– For auxiliary pools only, if you want to assign the pool to a specific
button, press 3. A display similar to the following appears:
Pool Ext Assign 15 P881
3 Select a Button
Then press a button with lights to assign the auxiliary pool to that button. If
you use option 3 after an auxiliary pool has been assigned, the auxiliary
pool moves from the old button to the new button you select.
5. At this point:
â– To assign another pool for this extension, press n or p
until the pool access code shows on the display. Then repeat Step
4.
â– To program another extension, press N P and
begin at Step 2.
6. Select another procedure or exit programming mode.
To Next Page
Loading...
Need help?
General
