Feature Reference
5-234
4. Press
e to start the restore.
If the system detects an error before beginning the restore, the bottom line
of the display shows one of the following messages:
Insert Card or Insert Valid Card
Bad File or Bad File - Try Again
Incompat Version or Incompatible Versions
Empty File
(See Chapter 6, ‘‘Troubleshooting’’, for more information about these
messages.)
If the system does not detect an error, the restore begins.
When the restore has completed successfully, the bottom line of the
display shows
Restore Complete
for two seconds. Then the system
resets itself, which means that all calls in progress are disconnected. You
are no longer in System Programming mode.
If the restore is not successful, the display shows
Restore Failed
or
Restore Failed-Try Again
for two seconds. All calls that were in progress
are disconnected and all of the system and telephone programming
settings revert to the default settings. You are no longer in System
Programming mode. Try the restore again.
To Next Page
Loading...
