VMS Cover (F15)
5-281
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
as
s and e on system phones.)
To program a VMS Cover button:
1. Press
f 0 0 s s c at extension
10 or 11.
2. Enter the number of the extension to be programmed with this feature.
3. Press a programmable button with lights.
4. Press
f 1 5.
5. Program another button for this extension or exit programming mode.
Using
From a system phone, press the programmed button to turn VMS Cover on; press
it again to turn it off. Use the button like a switch—when the light is on, VMS Cover
is on and your unanswered intercom and transferred calls or outside calls on lines
assigned ownership go to your voice mailbox after the specified number of VMS
Cover Rings.
If you turn on VMS Cover while a call is ringing, the call is sent immediately to
your voice mailbox.
If VMS Cover is already on and a call begins to ring, you can turn on Do Not
Disturb to send that call and any subsequent calls immediately to your voice
mailbox.
To Next Page
Loading...
