VMS Hunt Schedule (#507)
5-287
Programming
For Release 2.0 or Earlier:
(See Figure 2-3 on page 2-22
for the location of special programming buttons such
as
s and e on system phones.)
To change the VMS Hunt Schedule setting for the voice messaging system’s
Automated Attendant Service:
1. Press
f 0 0 s s # 5 0 7 at extension
10 or 11.
2. Press
D until the appropriate value displays.
3. Select another procedure or exit programming mode.
For Release 3.0 or Later:
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
as
s and e on system phones.)
To change the VMS Hunt Schedule setting for the voice messaging system’s
Automated Attendant Service:
1. Press
f 0 0 s s # 5 0 7 at extension
10 or 11.
2. Enter the line number.
The current setting displays.
3. To set VMS Hunt Schedule, press D until the appropriate value
displays. (See ”Valid Entries” above.)
4. To set VMS Hunt Schedule for another line, press
n or p until
the line number shows on the display. Then repeat Step 3.
5. Select another procedure or exit programming mode.
To Next Page
Loading...
