Troubleshooting
6-6
Display Shows Only 16 Characters per Line
Possible Cause:
A power outage occurred.
What to do:
Unplug the modular telephone cord from the phone then plug it in again.
If the display is still incorrect, see ‘‘System Phone Does Not Work’’ on page 6-5.
Display Is Incorrect
Possible Cause:
Date, day, and time are not set properly.
What to do:
Re-enter the date, day, and time using System Date (#101), System
Day (#102), and System Time (#103).
■ If the display is correct, the problem is solved.
■ If the display is still not correct, see ‘‘System Phone Does Not Work’’ on
page 6-5.
Display Shows “ReplaceSysBat W/Power On”
or “ChgBat W/PowerOn” at Extensions 10 and 11
Possible Cause:
System battery power is low.
What to do:
Replace the system batteries (see
Partner Advanced
Communications Installation
guide).
Display Does Not Show Caller ID Name/Number
Possible Cause 1:
Not receiving Caller ID service from local phone company.
What to do:
Contact your local phone company to check on Caller ID service.
■ If you are not receiving Caller ID service, subscribe to it.
■ If you are receiving Caller ID service, go to Possible Cause 2.
Possible Cause 2:
Extension connected to a module that does not support
Caller ID.
What to do:
Make sure lines with Caller ID service are connected to a PARTNER
ACS processor module, or 206EC, 308EC, or 400EC modules. If Caller ID lines
are not connected to one of these modules, install the appropriate modules and/or
make the appropriate connections.
Possible Cause 3:
Someone activated Call Coverage.
What to do:
Check the system phone display.
■ If
Coverage Call for XX
(where XX is the extension that activated the
Call Coverage) displays, the call is a coverage call. Call Coverage displays
the extension number of the person who activated the feature rather than
Caller ID information.
To Next Page
Loading...
