38
n-Gen
ColorFabb nGen filament is engineered for prototyping and production. This co-polyester
filament by colorFabb brings together the strength and precision found in Eastman Amphora™
3300 3D polymer, optimized for desktop 3D printing. Create durable, sturdy prints with this
easy-to use filament!
nGen handles complex models well, including bridging gaps, holes, and overhangs. It also
exhibits minimal warping and responds well to post-processing techniques like sanding. This
material is ideally suited for interlocking parts due to its low shrink rate and excellent layer
adhesion.
nGen adheres well to our PEI print surface. We strongly recommend applying PVA glue directly
on the print surface using a glue stick before printing to ensure easy part removal.
Extrusion Temperature: 230°C
PEI Print Surface Temperature: 85°C
Part Removal: 50°C
Tips: Printing Large Items? Treat PEI Print
Surface with PVA glue stick.
NinjaFlex
NinjaFlex 3D printing filament performs with an exciting combination of elongation, elasticity,
and strength. This fun, flexible material is the strectchiest filament we have ever tested! Its
soft, yet durable elasticity makes it ideal for costumes, cell phone cases, covers, grips, and thin
sturdy membranes.
NinjaFlex 3D printing filament adheres exceedingly well to our PEI print surface. We strongly
recommend printing on the bare glass side of the Modular Print Bed System or applying PVA
glue (white school glue) directly on the print surface using a glue stick (such as Elmer’s® brand)
before printing to ensure easy part removal.
Extrusion Temperature: 235°C
PEI Print Surface Temperature: 40°C
Part Removal: Off
Tips: Print on bare glass or treat PEI print
surface with PVA glue stick.
To Next Page
Loading...
