What to do if my Lumens Security Camera VC-G50 has no image output?
If your Lumens Security Camera VC-G50 isn't displaying an image, here are a few things to check: * First, verify that the power is on. * Next, confirm that the DIP switch is set correctly. * Also, ensure your display supports the output resolution, which is generally 1080p60/1080i60/720p60. * Finally, try replacing the cables to rule out any faulty connections.
Why my Lumens Security Camera VC-G50 cannot be operated by remote control?
If you're having trouble operating your Lumens Security Camera VC-G50 with the remote control, consider the following: * Confirm that the Camera Select on the remote control is compatible with the IR Select on the VC-G50. * Ensure the VC-G50 isn't exposed to direct sunlight. * Keep energy-saving bulbs and IR touch screens as far away as possible to prevent interference. * If multiple VC-G50 units are in the same area, operating two remote controls simultaneously may cause signal interference. It's best to use only one remote control at a time.
How to fix Lumens Security Camera not working after DIP switch change?
If your Lumens Security Camera isn't working after you've changed the DIP switch settings, unplug the power cord, reconnect it, and then turn the camera back on. This should apply the new settings.
What to do if Lumens VC-G50 cannot be controlled with RS-232/RS422?
If your Lumens Security Camera cannot be controlled with RS-232/RS422, first, check to ensure the connection is correct (RS-232/422 Input). Also, verify that System Switch DIP1 and DIP3 are set correctly.
Why is the image from my Lumens Security Camera VC-G50 severely delayed?
If the image from your Lumens Security Camera VC-G50 is severely delayed, try using 1080p or 720p signals at 60/50 Hz instead of 25/30 Hz signals.
How to fix Lumens Security Camera that won't boot?
If your Lumens Security Camera won't boot, make sure that the power cord is properly plugged in and that the Service DIP switch is set to Off.
Essential safety instructions for operating the camera.
Pre-installation checks and environmental considerations.
Procedures for desk and ceiling camera installation.
Detailed description of each button on the remote control.
Guide to accessing and configuring camera settings.
Configuring camera output modes via DIP switches.
General| Frame Rate | 30 fps |
|---|---|
| Optical Zoom | 20x |
| Power | DC 12V |
| Aperture | F1.6 - F3.5 |
| Operating Temperature | -10°C to 50°C |
| Ingress Protection | IP66 |
| Image Sensor | 1/2.8" CMOS |
| Resolution | 1920x1080 |
| Effective Pixels | 2.07MP |
| Video Output | HDMI |
| Control Interface | RS-232 |
| Lens | f=4.7mm - 94mm |
| Minimum Illumination | 0.5 Lux (Color) |
| Video Compression | H.264 |
| Network Interface | RJ45 |
To Next Page
