What to do if Lumens Security Camera VC-G30 cannot be operated by remote control?
If your Lumens Security Camera VC-G30 isn't responding to the remote control, ensure the Camera Select on the remote is compatible with the IR Select setting on the VC-G30. Also, prevent direct sunshine on the VC-G30. Keep energy-saving bulbs and IR touch screens as far away as possible to avoid interference. It is recommended to use only one remote control.
What to do if there is no image output from Lumens Security Camera VC-G30?
If you're not getting any image output from your Lumens Security Camera VC-G30, start by checking the power. Next, verify that the DIP switch is properly set. Ensure that your display supports the output resolution, typically 1080p60/1080i60/720p60. Finally, replace the cables to make sure they are not faulty.
What to do if my Lumens VC-G30 is not working after changes to DIP Switch setting?
After you change the DIP Switch settings on your Lumens Security Camera, unplug the power cord, reconnect it, and then turn the camera on. This will apply the new settings.
Why is the VC-G30 Lumens Security Camera image severely delayed?
If the VC-G30 Lumens Security Camera image is severely delayed, try using 1080p or 720p 60/50 Hz signals instead of 25/30 Hz signals.
What to do if Lumens VC-G30 Security Camera device cannot be controlled with RS-232/RS422?
If your Lumens Security Camera cannot be controlled with RS-232/RS422, first, verify that the connection is correctly established to the RS-232/422 Input. Second, ensure that System Switch DIP1 and DIP3 are properly configured.
How to fix Lumens VC-G30 that won't boot?
To fix a Lumens Security Camera that won't boot, first, ensure the power cord is properly plugged in. Second, check that the Service DIP switch is set to Off.
General safety guidelines for camera setup and usage.
Steps to ensure a safe and proper environment for camera installation.
Procedures and precautions for installing the camera on a desk.
Cautions regarding handling and mounting the camera on a desk.
Procedures and requirements for mounting the camera on a ceiling.
Safety guidelines and recommendations for ceiling mounting the camera.
Step-by-step instructions for attaching mounting plates during ceiling installation.
Procedure for safely removing the camera from its ceiling installation.
Guide to connecting the camera to various output devices.
Methods for controlling the camera using a computer via RS-232 or RS-422.
Lists and describes the functions of buttons on the remote control.
Details the menu structure and options for camera settings.
Configuration options for exposure mode, AE level, spot light, and shutter priority.
Settings related to iris priority, manual iris, and gain limit.
Manual adjustment of gain and shutter speed for image control.
General| Frame Rate | 30 fps |
|---|---|
| IR Distance | Up to 30 meters |
| Ingress Protection | IP66 |
| Sensor | 1/2.8" CMOS |
| Resolution | 1920 x 1080 (1080p) |
| Minimum Illumination | 0.01 Lux |
| Day/Night | Yes |
| Video Compression | H.264 |
| Audio | Audio input |
| Network | 10/100 Ethernet |
| Power Supply | DC 12V |
| Operating Temperature | -10°C to +50°C |
| Digital Zoom | 4x |
| Tilt Angle | 90° |
| Video Output | HDMI |
To Next Page
