Lumens VC-TR60 - Page 34

English-33
5.2.12 System - Control
No
Item
Function Descriptions
1
Protocol
VISCA protocol is supported
2
Baud Rate
Choose the transmission speed of the control signal as
9600/38400
3
VISCA address
The camera ID address 0 ~ 7 can be assigned
4
Tally Lamp
Enable/Disable Tally Lamp
5
Tally CMMD Mode
Set whether the indicator light is linked with RS232 command
 General (Not linked): The indicator light switch and mode
shall be set separately.
-When the indicator light is on and the default mode is off,
additional command is required to set the indicator light
mode
-Setting the indicator light mode when the indicator light is
off will not trigger the indicator light
 Link:
-When the indicator light is on, the default mode is red light
-Setting the indicator light mode when the indicator light is
off will turn on the indicator light
6
Apply/Cancel
Apply/Cancel Setting
○
1
○
2
○
3
○4
○
5
○
6
○
7
○7