LS200-INS-LAB-RevB17
9
4 HANDLING PROCEDURES
UNPACKING
1. Check for any obvious damage to the carton or its contents. If damage is evident, notify the
carrier or your GF authorized distributor.
2. Open shipping container.
s NOTICE:Donotusesharpinstrumentstoopenboxes.Damagetomattresscouldresult.
3. Remove contents.
4. Remove Mattress System from protective plastic cover.
The mattress may appear wrinkled when unpacked. To remove wrinkles, allow mattress up
to 24 hours to accommodate. Wrinkles will not affect ination or function. Mattress may be
used immediately if needed.
5. Check mattress surface for tears or cracking; do not use if tears or cracking are present.
STORAGE
Pump
• Check the power cord and plug for abrasions and excessive wear.
• Plug in the unit and verify air ow from the hose connection ports.
• Place in plastic bag for storage.
Mattress
• Check the air manifold for kinks or breaks. Replace if necessary.
• Twist open the CPR plug at the head of the mattress and disconnect the air feed tubes. All of
the air will be expelled. Starting at the head of the mattress roll towards the foot of the bed.
Use the base mounted straps to secure.
• Place the system in a plastic bag for storage.
• Store in a dry, controlled climate room.
• DO NOT place other objects on top of the repackaged Mattress System.
WASTE DISPOSAL
ThisProducthasbeensuppliedfromanenvironmentallyawaremanufacturerthat
complieswiththeWEEE.Thisproductmaycontainsubstancesthatcouldbe
harmfultotheenvironmentifdisposedofinplaces(landlls)thatarenotappropriate
accordingtolocallegislation.Pleasebeenvironmentallyresponsibleandrecycle
thisproductthroughyourrecyclingfacilityatitsendoflifeordisposeofitin
accordancewithlocalregulations.
To Next Page
Loading...
Need help?
General
