7 OPERATION/USE
LUMINELL SWEDEN AB 41
2. Pos (fixed positions)
There are up to four fixed position memories (A, B, C and D) which can be individually
programmed. By a short button press on F1-F4 the searchlight will move to the
corresponding preprogrammed position. When selected the position background will turn
green, this applies until position is changed manually.
Set fixed position
Press and hold the function button 6 seconds for the position you want to set/change.
When the below menu “position settings” is shown in the display the searchlight can be
moved to the position you wish to store, if desired you can also adjust the light dim level and
beam angle to be stored for that position.
Confirm new position setting with "OK" or exit the menu with "Back".
If the searchlight doesn’t move when commanding a position A-D, then either position is not
stored, or the searchlight is already in this position.
To Next Page
Loading...
