7 OPERATION/USE
LUMINELL SWEDEN AB 42
3. Sweep
At sweep mode, the searchlight automatically moves back and forth between two individually
programmable positions in the horizontal plane. A short button press on F1 starts and stops
the sweep.
The sweep always starts from the current position, which then becomes the center point for
the sector. During sweep, the tilt joystick can still be used to adjust the light up / down.
To interrupt the sweep, press "Stop sweep" or move the wheel in any direction.
Modify sweep
To change the sweep parameters, press the “Modify sweep” button.
In this menu, both sector size and sweep speed can be changed, if no changes are made,
the default sector size is 45° and speed 50% (of max speed).
To step between the parameters, use the tilt joystick up/down. the selected parameter is
marked with a blue background. To increase or decrease the value, use the wheel.
The last set sector size and speed is stored by the system and used during sweep.
If no change is made the default sector size is 45° and speed 50% (of max speed).
To Next Page
Loading...
