7 OPERATION/USE
LUMINELL SWEDEN AB 43
3. Surveillance
Surveillance is an advanced sweep function where both horizontal and vertical movement
interact at the same time.
The searchlight can be set to sweep between 2-5 pre-set positions, at each position the
beam angle and light intensity can be stored together with a desired pause time.
Start surveillance
The surveillance function can be activated and deactivated from Sweep screen, if a shortcut
is created, also from the Homescreen.
Modify surveillance
Before the surveillance function can work properly, the desired positions and other
parameters must be programmed.
On “Sweep screen” select” Modify surveillance” and confirm with “OK”.
If it is the first time you look into this function, we suggest you start with the “Surveillance
settings” parameters, confirm with “OK”.
To Next Page
Loading...
