LUMINELL SL1 - Surveillance Settings and Positions

7 OPERATION/USE
LUMINELL SWEDEN AB 44
Surveillance settings
Positions to use: In surveillance settings you can set the number of positions you want to
use in your surveillance setup, 2-5 positions can be selected.
Use the tilt joystick to select the settings to change and the control wheel to adjust.
Mode: This sets the searchlights sweep behaviour between the positions and there are two
different settings to use.
Back & forth
When the searchlight reaches the last position and any pause time has elapsed, it restarts on
position 1. Back & forth will loop until interrupted by user.
Repeat
When the searchlight reaches the last position and any pause time has elapsed, it reverses
back towards position 1. Repeat will loop until interrupted by user.
Speed: This sets the sweep speed between the positions; the speed parameter is selected
in steps of 5 between 10-100%.
The surveillance sweep can be interrupted by pressing “Stop surveillance” or by turning the
control wheel in any direction, light status for recent position will still be active.
POS
1
POS
2
POS
3
POS
4
POS
5
POS
1
POS
2
POS
3
POS
4
POS
5