7 OPERATION/USE
LUMINELL SWEDEN AB 45
Set surveillance positions
Under "Modify surveillance" you also set the actual positions to be used during the sweep, up
to 5 positions can be set and for each position individual light angle and fog level can be
stored. For example, select "position 1" with the panel's tilt joystick, confirm with “OK”.
An active menu opens and if “Position 1” is empty, nothing happens. If a previous position is
stored the searchlight will move there and activate any stored light parameters.
To update "Position 1", use the control wheel and tilt joystick and operate the light to the new
position, if desired, also adjust the beam angle and dim level. Store the new position with
"OK". The control wheel light indicator confirms the position with two white flashes.
Now the pause menu opens, here you set the number of seconds that the searchlight should
stop at, in this case, position 1. Adjust between 0 to 10 seconds with the control wheel,
default setting is 5 seconds. “OK” confirms the new setting and "Modify surveillance" menu
reappears.
To Next Page
Loading...
