3-10
CDA3000 Operation Manual
3 Electrical installation
3.7 Control
terminals
Step Action Comment
1
Check whether your inverter module is
fitted a modified software package
(Sxx) and/or a ready-to-run data set
(Dxx).
If this is the case, the control terminal
assignment is different. Please con-
tact your project engineer with regard
to wiring and commissioning!!
Position of software name plate - see
section 3.1 page 3-2
2
Check whether you already have a
S
MARTCARD or a DRIVEMANAGER DATA
SET with a complete device setup.
If this is the case, the control terminal
assignment is different. Please con-
tact your project engineer to obtain
the terminal assignment!
Bulk customers
For details of how to load the data
set into the inverter module refer to
section 4.6.
3
Choose a terminal assignment.
See 3.7.1 "Choice of terminal
assignment"
4
Wire the control terminals with
shielded cables.
The only essential signals are the
ENPO signals and a start signal
(STR or STL).
Ground the cable shields over a
wide area at both ends.
Wire cross-section maximum
1.5 mm² or two wires per terminal
with 0.5 mm²
5
Keep all contacts open
(inputs inactive).
6
Check all connections again!
Continue with commissioning in
section 4.
Note the following points:
• Always wire the control terminals with shielded cables.
• Lay the control cables separately from the mains lead and motor
cable.
• The CDA3000 Application Manual presents more drive solutions.
ANTRIEBSTECHNIK
D- 35633 Lahnau
Type: CDA32.004,C1.0
Software: V1.10, S xx
C1D1
CS:
D xx
Data Set:
SN.: 99120442
To Next Page
Loading...
