Lutron Electronics AuroRa User Manual

The central antennas should be at least
3 feet apart and within 60 feet of each
other when bridging two systems.
Page 6
Page 15
Need help? Call the Lutron Technical Support Center, 24/7 at 800.523.9466
Installing A Dimmer For Lights Controlled
By One Switch
Uninstall switch
A. You should see two
insulated wires attached to
the switch. A green or bare
wire is a ground wire.
B. Disconnect the wires from
the switch.
4
Remove wallplate
Remove existing switch
WARNING: Power
must be turned off
for your safety.
1
2
3
Helpful Hint:
Save your wallplate
and screws.
Turn power off at circuit breaker or remove fuse
1
2
Adding to Your System
Bridging AuroRa® Systems
Bridged System Functionality
To bridge two systems, press and hold the “Bridge”
button on the central antenna of either system for 3
seconds. The “Bridge” LED should flash slowly.
2
The systems are now bridged.
5
Press and hold the “Bridge” button on the second
central antenna for 3 seconds. The “Bridge” LED
should flash slowly.
The LEDs on both central antennas will begin to
flash quickly as the bridging process starts.
The loads in both systems will start flashing.
When the process is finished, the “Bridge” LEDs on
both central antennas will stop flashing and stay
on. The loads in both systems will stop flashing.
“All On” Button
All dimmers in both systems will turn on to full brightness.
“All Off” Button
All dimmers in both systems will turn off.
“Favorite” Button
All dimmers in both systems will turn on to their
local slider levels.
3
Need help? Call the Lutron Technical Support Center, 24/7 at 800.523.9466
4
All On All Off
Rooms
Fr Entry
Grge Ext
Foyer
Kitchen
Family
All On All Off Favorite
Purchase and install two separate AuroRa systems.
1
RF Communication
System Visor
Advanced
Bridge
Add
Power
RF Communication
Sys
tem Visor
Advanced
Bridge
Add
Power
Helpful Hint:
Use the Lutron screwdriver (supplied)
to help remove “pushed-in” wires on
existing switch.
RF Communication
Sys
tem Visor
Advanced
Bridge
Add
Power
RF Communication
Sys
tem Visor
Adv
anced
Bridge Add
Power
RF Co
mmunication
Sys
tem Visor
Advanced
Bridge Add
Power
RF Co
mmunication
Sys
tem Visor
Advanced
Bridge Add
Power
RF Communication
Sys
tem Visor
Advanced
Bridge Add
Power
RF Communication
Sys
tem Visor
Advanced
Bridge Add
Power
For information about returning your system to its
original default settings, visit www.lutron.com/aurora.
?

Lutron Electronics AuroRa Specifications

General

Brand	Lutron Electronics
Model	AuroRa
Category	Control Systems
Language	English