1) Prepare the Probe ( CDPB-04, same probe as the
conductivity measurement, refere to Fig. 1, page 6 ),
install the " Probe Plug " ( 3-20, Fig. 1 ) into the "
Probe Socket " ( 3-13, Fig. 1 ).
2) Power on the meter by pressing and holding " Power Button "
( 3-2, Fig. 1 ) for at least 1.5 seconds .
Select the Meter's measurement FUNCTION to " SALT", refer
to Chapter 4, page 7 .
3) Hold the " Probe Handle " ( 3-18, Fig. 1 ) by hand
and let the " Sensing head " ( 3-19, Fig. 1 )
immersed wholly into the measured solution. Shake
the probe to let the probe's internal air bubble drift
out from the sensing head.
Display will show the Salt values ( % weight ).
6-2 Calibration
If the conductivity range already make the calibration
completely then the Salt measurement is not necessary to
make the calibration again.
12
To Next Page
Loading...
