Lutron Electronics CD-4318SD - Manual Datalogger ( Set Sampling Time = 0 Second ); Check Time Annd Sampling Time Information

second )
a. Set sampling time is to 0 second
Press the " LOG Button ( 3-8, Fig. 1 )>1.5 second, the LCD
will show the indecator " LOGGER " and " Position no. " symbol
then press the " LOG Button " ( 3-8, Fig. 1 ) once , the
" LOGGER " symbol will flashing once and Beeper will sound
once at the same time the measuring data along the time
information will be saved into the memory circuit .
Remark :
During execute the Manual Datalogger, it can use the " ▲
▲▲
▲
Button " ( 3-5, Fig. 1) or " ▼
▼▼
▼ Button " ( 3-6, Fig. 1 ) to
set the measuring position ( 1 to 99, for example room 1
to room 99 ) to identify the measurement location , the
lower Display will show P x ( x = 1 to 99 ).
b. Finish the Datalogger
During execute the Datalogger function, press the " LOG
Button ( 3-8, Fig. 1 ) > 1.5 seconds continuously again will
finish the Datalooger function, the Position no. " PXX " will
be disappeared and finish the Datalogger. function.
least two seconds, the " LOGGER " indication will be
disappeared and finish the Datalogger.
8-4 To check the time and sampling time information
During the normal measurement ( not execute the
Datalogger ), If press " Time " ( 3-7, Fig. 1 ) )
once , the LCD display will present the time
information of Year/Month, Date/Hour, Minute/Second
and the Sampling time information .
16
8-5 SD Card Data structure