Lutron Electronics CD-4318SD - Page 17

a. Start the datalogger
Press the " LOG Button ( 3-8, Fig. 1 ) > 1.5 seconds
continuously, the LCD will show the text of " LOGGER "
indecator and flashing per sampling time, at the same
time the measuring data along the time information will
be saved into the memory circuit.
Remark :
*
How to set the sampling time, refer to Chapter 10-2 ,
page 21 .
*
How to set the beeper sound is enable, refer to
Chapter 10-4, page 22 .
b. Pause the datalogger
During execute the Datalogger function, if press the
" LOG Button " ( 3-8, Fig. 1 ) once will pause the
Datalogger function ( stop to save the measuring data
into the memory circuit temporally ). In the same time
the " LOGGER " symbol will stop flashing.
Remark :
If press the " LOG Button " ( 3-8, Fig. 1 ) once again
will execute the Datalogger again, the " LOGGER "
symbol will flashing.
c. Finish the Datalogger
During execute the Datalogger function, press the
" LOG Button ( 3-8, Fig. 1 ) > 1.5 seconds continuously
again will finish the Datalooger function, the " LOGGER "
text will be disappeared and finish the Datalogger function.
15
8-3 Manual Datalogger ( Set sampling time = 0