Lutron Electronics CD-4318SD - Page 23

The adjusted value will be flashed.
2) After set all the time value ( Year, Month, Date, Hour,
Minute, Second ), press the " SET Button " ( 3-7, Fig.
1 ) once will save the time value, then the screen will
jump to Sampling time " setting screen ( Chapter 10-2 ).
Remark :
After the time value is setting, the internal clock will
run precisely even Power off if the battery is under
normal condition ( No low battery power ).
10-2 Set sampling time ( Seconds )
When the upper display show " SP T "
1) Use the " ▲ Button " ( 3-5, Fig. 1 ) or " ▼ Button "
( 3-6, Fig. 1 ) to adjust the value ( 0 to 3600 seconds ).
Remark :
press and holding "▲ Button "or"▼ Button " to adjust the value,
will be a digits increase or decrease .
if press and holding "▲ Button "or"▼ Button " > 2 second to
adjust the value, ten digits increase or decrease .
2) After the Sampling value is selected, press the "
Enter Button " ( 3-8, Fig. 1 ) will save the setting
function with default.
10-3 Auto power OFF management
When the lower display show " POFF "
21
1) Use the " ▲ Button " ( 3-5, Fig. 1 ) or " ▼ Button "