Lutron Electronics RADIO RA2 - assign dimmer;switch and set level

24/7 Technical Support—800.523.946616
|
Lutron®
Steps 3 to 7 cover assigning devices to the selected button and
setting the levels for those devices. To assign the devices, follow the
step appropriate to that device:
3. Assign Dimmer/Switch and set level
i. Press and hold the main button on
the Dimmer/Switch to be assigned for
3seconds.
When the Dimmer/Switch has been
successfully assigned, the load connected
to the Dimmer/Switch will turn on/off 3 times
and the LED(s) will normal-flash.
Note: To unassign a Dimmer/Switch, press
and hold the main button on the Dimmer/
Switch for 3 seconds until the load turns
on/off 3 times and the LED(s) turn off.
ii. Adjust the level of the assigned Dimmer/
Switch to the desired setting using the raise/
lower buttons on the Dimmer, or using the
main button on the Dimmer/Switch to turn the
device off.
Note: A Dimmer/Switch assigned to a Room
Status Keypad button cannot be set to Off.
Note: To assign additional Dimmers/
Switches to the currently selected Keypad
button, repeat step 3.
Note: To program another Keypad button,
restart at step 2.
programming buttons
Step
3
Step
7
Steps
5-6
Step
4
Hybrid
Step
7
LUTRON
LUTRON
LUTRON