Lutron Electronics RADIO RA2 - assign hybrid keypad and set level

www.lutron.com/radiora2 Lutron®
|
17
4. Assign Hybrid Keypad and set level
i. Press and hold the raise and lower
buttons on the Hybrid Keypad to be
assigned for 3 seconds.
When the Hybrid Keypad has been
successfully assigned, the load
connected to the Hybrid Keypad will
turn on/off 3 times and the LEDs will
normal-flash.
Note: When a button on a Hybrid
Keypad is assigned to the local load of
that Hybrid Keypad, the LED of the button
being programmed will flash 2 times
followed by a single flash of all the LEDs.
Note: To unassign a Hybrid Keypad,
press and hold the raise and lower
buttons on the Hybrid Keypad for
3seconds until the load turns on/off
3times and the LEDs turn off.
ii. Adjust the level of the assigned Hybrid
Keypad to the desired setting using the
raise/lower buttons on the Hybrid Keypad.
To toggle the Hybrid Keypad on/off, press
and release the raise and lower buttons at
the same time.
Note: A Hybrid Keypad assigned to a
Room Status Keypad button cannot be
set to Off.
Note: To assign additional Hybrid
Keypads to the currently selected Keypad
button, repeat step 4.
Note: To program another Keypad button,
restart at step 2.
programming buttons