Lutron Electronics RADIO RA2 - assign zones to grafik eye qs wireless unit

24/7 Technical Support—800.523.946618
|
Lutron®
Individual zones and single scenes can be assigned to buttons on
GRAFIK Eye
® QS Wireless units, but not both to the same unit.
Step5 covers assigning zones to a button, and step 6 covers
assigning a scene to a button. If assigning single scenes to buttons,
skip ahead to step 6.
5. Assign individual zones to a GRAFIK Eye
® QS Wireless unit
and set levels
i. Simultaneously press the raise and lower
buttons of the zone to be assigned.
When the zone has been successfully
assigned, the zone LEDs will normal-flash.
Note: To unassign a zone, simultaneously
press the raise and lower buttons until only
the 3 middle LEDs are lit.
ii. Adjust the level of the assigned zone
to the desired setting using the raise/lower
buttons of the zone. While adjusting levels,
the zone LEDs display the level and do not
flash. Tapping another zone resumes flashing
on the previous zone. After 3 seconds of
inactivity, the assigned zone LEDs resume
flashing.
Note: To assign additional zones to the
currently selected Keypad button repeat
step5.
Note: To program another Keypad button,
restart at step 2.
Note: If individual zones were assigned to
a GRAFIK Eye
® QS Wireless unit, skip step
6 for this GRAFIK Eye
® QS Wireless unit.
Individual zones and single scenes can not
be assigned to the same GRAFIK Eye
® QS
Wireless unit.
programming buttons