Lutron Electronics RADIO RA2 - assign scenes to grafik eye qs wireless unit

www.lutron.com/radiora2 Lutron®
|
19
6. Assign single scenes to a GRAFIK Eye® QS Wireless unit
and set levels
Note: Both individual zones and single
scenes can not be assigned to the same
GRAFIK Eye
® QS Wireless unit.
i. Press the OK button to enter the
Scene menu.
ii. Use the Master raise/lower buttons to
select the desired scene, then press the
OK button to confirm the selection.
When the scene has been successfully
assigned, all zone LEDs will flash at their
scene preset levels and loads will go to the
assigned scene.
Note: To assign additional scenes to
the GRAFIK Eye
® QS Wireless unit, repeat
step6.
Note: When a zone has a preset level of
OFF, the zone LEDs will not flash.
Note: To change the GRAFIK Eye® QS
Wireless unit back to individual zones, use
the Master raise/lower buttons to select
“Zones”, then press the OK button.
Note: Scenes can only be programed
locally at the GRAFIK Eye
® QS Wireless unit.
Note: To unassign a scene, press the
OK button then use the Master raise/
lower buttons to select “Unassign”, then
press the OK button to complete the
unassignment.
Note: To program another Keypad
button, restart at step 2.
programming buttons