Lutron Electronics RADIO RA2 - assign sivoia qs wireless shade;drapery

24/7 Technical Support—800.523.946620
|
Lutron®
7. Assign Sivoia® QS Wireless Shade/Drapery and set level
A. Roller Shade/Drapery
i. Press and hold the open button ( ) or
close button (
) on the Electronic Drive
Unit (EDU) to be assigned for 3seconds.
When the Roller Shade/Drapery has been
successfully assigned, the green LED on the
EDU will rapid-flash.
Note: To unassign a Roller Shade/
Drapery, press and hold the open or close
button for 3seconds. The LED on the EDU
will flash twice in 2 seconds, then turn off
for 8seconds.
ii. Adjust the level of the assigned Roller
Shade/Drapery to the desired setting using
the raise/lower buttons (
and ).
To raise the Roller Shade/Drapery to the fully
open position, double-tap the open button
(
). To lower the Roller Shade/Drapery to
the fully closed position, double-tap the
close button (
).
programming buttons