10-3 Manual Datalogger ( Set sampling time = 0
second )
a. Set sampling time is to 0 second
Press the " LOG Button ( 3-8, Fig. 1 ) > 2 Sec. , the LCD up block
will show the text " LOGGER ", then press the " Logger Button " (
3-8, Fig. 1 ) once, the up block text " LOGGER " will flashing once
and Beeper will sound once, at the same time the measuring
data along the time information will be saved into the memory
circuit. The lower Display will show the Position ( Location ) no.
and saved into the SD card too.
Remark :
During execute the Manual Datalogger, press the " ▲
Button " ( 3-5, Fig, 1 ) the lower no. ( position no. ) will
flashing. It can use the " ▲ Button " ( 3-5, Fig. 1) or "
▼ Button " ( 3-6, Fig. 1 ) to set the measuring position (
1 to 99, for example room 1 to room 99 ) to identify the
measurement location , the lower Display will show P x (
x = 1 to 99 ).
b. Finish the Datalogger
Press the " LOG Button " ( 3-8, Fig. 1) continuously at
least two seconds, the " LOGGER " indication will be
disappeared and finish the Datalogger.
34
To Next Page
Loading...
