Lutron Electronics WAC-2019SD - 7 SALT MEASURING and Calibration PROCEDURE

* Multi-points calibration procedures should execute the
2 mS range ( 1.413 mS Cal. ) calibration at first, then
make other ranges (20 uS range, 20 mS range or 200 mS
range ) calibration procedures following if necessary.
7)
If select the clear point, press the " Enter Button " (
3-8, Fig. 1 ) will clear existing calibration data.
8)
If select the Escape Calibration, press the " Enter Button "
(3-8, Fig. 1 ) will Escape Calibration Function and back nomal
measurement.
7. SALT MEASURING and
CALIBRATION
Fig. 4
23