Lutron Electronics YK-2001PHA - Page 38

10-8 Set pH manual Temp. compensation value
When the lower display show " t-SEt "
1) This function only for the pH measurement of
adjusting the pH electrode's manual Temp.compensation
value. The default value is 25 ℃ ( 77 ℉ ).
2)
Use the " ▲ Button " ( 3-5, Fig. 1 ) or " ▼ Button "
( 3-6, Fig. 1 ) to select the upper value to the desired
Temp. compensation value ( ℃ or ℉ ), then press the
" Enter Button " ( 3-8, Fig. 1 ) will save the setting
value with default.
10-9 ESC
When the display show " ESC "
When the Display show the text " ESC ", then press the
" ESC Button " ( 3-3, Fig. 1 ) will finish the Advanced
Setting procedures and return to the normal measuring
screen.
Remark :
During execute the " Advanced Setting " function,
if press " ESC Button " ( 3-3, Fig. 1 ) will exit the
" Advanced Setting " function, the LCD will return
to normal screen.
36