Lutron Electronics YK-2001PHA - Page 37

2)
Use the " ▲ Button " ( 3-5, Fig. 1 ) or " ▼ Button "
( 3-6, Fig. 1 ) to select the upper value to the desired
height compensation value ( meter ), then press the
" Enter Button " ( 3-8, Fig. 1 ) will save the setting
value temporally.
10-6 Set DO height ( feet ) compensation value
When the lower display show " Highf "
1) This function only for the DO ( Disolved oxygen ) Function of
adjusting the probe's height compensation value in
feet unit. The default value is 0 FEET.
2)
Use the " ▲ Button " ( 3-5, Fig. 1 ) or " ▼ Button "
( 3-6, Fig. 1 ) to select the upper value to the desired
height compensation value ( feet ), then press the
" Enter Button " ( 3-8, Fig. 1 ) will save the setting
value temporally.
10-7 Set CD temperature compensation factor
When the lower display show " PEr C "
1) This function only for the Conductivity ( TDS ) Function of
adjusting the probe's Temp.compensation value in
%/per ℃ unit. The default value is 2 %/ per ℃.
2)
Use the " ▲ Button " ( 3-5, Fig. 1 ) or " ▼ Button "
( 3-6, Fig. 1 ) to select the upper value to the desired
Temp. compensation value ( %/per ℃ ), then press the
" Enter Button " ( 3-8, Fig. 1 ) will save the setting
value temporally.
35