Lutron Electronics YK-2001PHA - Page 36

10-3 Select the Temp. unit to ℃ or ℉
When the lower display show " t-CF "
1) Use the " ▲ Button " ( 3-5, Fig. 1 ) or " ▼ Button "
( 3-6, Fig. 1 ) to select the upper Display text to " C " or
" F ".
C - Temperature unit is ℃
F - Temperature unit is ℉
2) After Display unit is selected to " C " or " F ", press the
" Enter Button " ( 3-8, Fig. 1 ) will save the setting
function with default.
10-4 Set DO salt% compensation value
When the lower display show " SALt "
1)
This function only for the DO ( Disolved oxygen ) Function
of adjusting the probe's salt% compensation value.
The default value is 0% salt.
2) Use the " ▲ Button " ( 3-5, Fig. 1 ) or " ▼ Button "
( 3-6, Fig. 1 ) to select the upper value to the desired
salt% compensation value, then press the " Enter
" Enter Button " ( 3-8, Fig. 1 ) will save the setting
value temporally.
10-5 Set DO height ( meter ) compensation value
When the lower display show " High- "
1) This function only for the DO ( Disolved oxygen ) Function
of adjusting the probe's height compensation value in
meter unit. The default value is 0 meter.
34