Press or to select between ℃ and ℉.
Note: The buzzer will beep a short sound to remind you
that all the parameters have been restored to the default
data.
The controller will save the settings and exit automati-
cally if there's no operation in 60 seconds, or you can
hold for 2 seconds to exit settings manually.
Short press or to adjust the setting values, hold
， or to adjust the setting values quickly.
The controller will save the settings and exit automati-
cally if there's no operation in 60 seconds, or you can
hold for 2 seconds to exit settings manually.
When the current temperature of P1 is less than or
equal to the start heating temperature of P1, WORK1
will turn on the output and the heating symbol will light
up.
Hold for 2 seconds and press once again to
enter the setting menu, then select St1.
Start Heating Temperature of P1(ST1)
-7-
To Next Page
Loading...