The controller will save the settings and exit automati-
cally if there’s no operation in 60 seconds, or you can
hold for 2 seconds to exit settings manually.
When the current temperature of P2 is less than or
equal to the start heating temperature of P2, WORK2 will
turn on the output and the heating symbol will light up.
Hold for 2 seconds and press once again to
enter the setting menu, then select SP2.
Short press or to adjust the setting values, hold
. or to adjust the setting values quickly.
The controller will save the settings and exit automati-
cally if there’s no operation in 60 seconds, or you can hold
. for 2 seconds to exit settings manually.
When the current temperature of P2 is greater than or
equal to the stop heating temperature of P2, WORK2 will
turn off the output and the heating symbol will go out.
Stop Heating Temperature of P2(SP2)
-12-
To Next Page
Loading...