19
Memory
This unit memorizes the following items when the operation
switch is set to OFF or the main power switch is set to OFF:
Item Default
INPUT Selected source
OUTPUT MODE Selected mode
BI-AMP L-Hi : ±6dB, R-Hi : ±6dB
BAL PHASE INPUT-1, 2, 3 : 3±, 2±
OUTPUT : 3±, 2±
BAL INVERT NORMAL / INVERT
DIMMER Normal/Darker/Significantly
darker/No light
ZOOM ON / OFF
LOUDNESS ON / OFF
LINE-STRAIGHT ON / OFF
EXT PRE ON / OFF
Memory reset
The following operations restore all the settings to the factory
defaults.
(1) Turn this unit to the standby state.
(2) Hold down the operation switch on the main unit for 5
seconds or more and press the dimmer switch once while
holding down the operation switch.
That’s all for memory reset.
Factory default
Item Default
INPUT LINE-1
OUTPUT MODE UNBALANCE
BI-AMP L-Hi : 0dB, R-Hi : 0dB
BAL PHASE INPUT-1, 2, 3 : 3+, 2−
OUTPUT : 3+, 2−
BAL INVERT NORMAL
DIMMER MAX (under normal conditions)
ZOOM OFF
LOUDNESS OFF
LINE-STRAIGHT OFF
EXT PRE OFF
Inhibition and caution
When a setting cannot be changed, an error message as fol-
lows is displayed:
Display Caution
UNBALANCE
MODE!!
When the input and output are
both unbalance, the balanced
phase cannot be inverted.
BI-AMP
MODE!!
When the bi-amplifier output
is selected, the balanced input
cannot be selected.
BI-AMP
MODE!!
When the bi-amplifier output is
selected, the balanced phase
cannot be inverted.
STRAIGHT
MODE!!
When the line straight is set to
ON, loudness cannot be selected.
EXT PRE
MODE!!
When the external pre is set to
ON, mute cannot be selected.
EXT PRE
MODE!!
When the external pre is set to
ON, the output mode cannot be
changed.
IN: BAL.-*
VOL: -**dB
(no change in
display)
When the balanced input is
selected, the bi-amplifier output
mode cannot be selected.
To Next Page
Loading...
Need help?
General
