Need help?Do you have a question about the Luxman M-10X and is the answer not in the manual?
General| Type | Stereo Power Amplifier |
|---|---|
| Rated Output Power (8Ω) | 150W + 150W |
| Rated Output Power (4Ω) | 300W + 300W |
| Gain | 29dB |
| Instantaneous Maximum Output Power (4Ω) | 420W + 420W (4Ω) |
| Frequency Response | 5Hz - 100kHz (+0dB, -3dB) |
| Dimensions (W x H x D) | 440(W) x 193(H) x 426(D) mm |
| Signal-to-Noise Ratio (IHF-A) | 125dB |
Ensures proper placement for heat dissipation and airflow, avoiding direct sunlight or humid conditions.
Safety advice for connecting components and speakers, emphasizing power off and preventing short circuits.
Explains timed muting, protection circuit activation, and advice on repair and cleaning procedures.
Highlights the unit's weight and advises caution during handling and installation to prevent injury.
Details the 4x2 output structure, LIFES system, and dual FET input for enhanced sound quality.
Covers BTL connection mode, 2-channel input selector, and balanced input phase inversion.
Highlights the selector relay and the highly stable power supply circuit with high-capacity components.
Explains 4-parallel speaker relays for reduced impedance and Schottky barrier diodes for efficiency.
Details LUXMAN's OFC wiring, PCB design, loopless chassis, and cast-iron insulators for optimal performance.
Describes the large analog meter with selectable lighting and the robust speaker terminals for easy connection.
Identifies and explains the Standby/Operation indicators, Operation button, Input selector, and Display button.
Details the function of the Display button for meter lighting and the operation of the power meters.
Explains the BTL indicator for mono operation and how the input button selects between LINE and BAL LINE.
Describes the switch for stereo/BTL operation and the phase inverter for balanced inputs.
Explains the main power switch, signal ground terminal, and unbalanced input terminal.
Details the balanced input terminal, AC inlet, and trigger input/output terminals for system integration.
Explains speaker connections for stereo and BTL modes, and the procedure for memory reset.
Advises on initial connections, turning off power, and connecting the unit to the AC power supply.
Guides on connecting to control amplifiers or other input devices using various cable types.
Explains how to connect trigger input/output terminals and the limitations of output current.
Details correct wiring for left and right speakers in stereo mode, including polarity and phase.
Explains speaker connection for BTL (mono) operation, including precautions for switch boxes and direct connection.
Illustrates the wiring setup for normal stereo operation with a control amplifier and CD/SACD players.
Illustrates the wiring for BTL (mono) operation using two M-10X units and a control amplifier.
Diagram for bi-amplifier setup connecting control amp, players, and speaker systems for L-HIGH/LOW and R-HIGH/LOW.
Presents the overall block diagram of the M-10X amplifier, showing signal flow and component interactions.
Details rated output, maximum output, input sensitivity, and input impedance for various modes.
Lists harmonic distortion, frequency response, S/N ratio, damping factor, and power consumption.
Covers supplied functions, accessories, power supply requirements, dimensions, and unit weight.
Provides a table listing common issues, their causes, and solutions before contacting a dealer for repair.
To Next Page
