3
STEREO POWER AMPLIFIER M-10X
4-parallel speaker relay
The impedance of speaker output lines is reduced thanks
to the placement of a 4-parallel contact structure of speaker
relays with low resistance values for each channel.
Schottky barrier diodes
By using Schottky diodes, manufactured by KYOCERA
Corporation, this unit achieves very high DC conversion effi-
ciency in the power rectifier circuitry and much less switching
noise. In addition, a high voltage SiC Schottky diode made by
ROHM Co., Ltd. is used for the power rectifier circuit of the
voltage amplifier stage.
LUXMAN’s original OFC wiring
Our original OFC cable, with non-plated core wire, is used for
internal wiring to achieve smooth signal transmission.
Peel coat, PCB
Dielectric effect is eliminated by using 100 μm thick copper
foil and gold plating on the audio circuit boards instead of
using resist.
High-grade analog meter
Large-sized analog meter with a shower light equipped, light
OFF/meter OFF selectable.
Loopless chassis
This unit features a loop-less chassis, independently con-
structed to eliminate increases in ground impedance due to
chassis current.
Large speaker terminals
The speaker terminals have right and left identical layout char-
acteristics, which are compatible with Y lugs and enable easy
connection with extra-thick speaker cables.
Cast-iron insulators
For stability and support, this product features cast iron feet
with vibration reducing density gradient.
To Next Page
Loading...
Need help?
General
