Luxman M-10X - Connections; Before Connecting and Power Supply; Connecting Input Devices; Trigger and Output Connections

8
Connections
Before connecting
Before connecting other devices, connect the jack side of the
accessory power cable to the AC inlet of this unit.
Before connecting this unit, turn off the main power button
of this unit and the power of all other connected devices to
prevent unexpected accidents that may be caused by noise.
Connecting to the power supply
Connect the supplied accessory power cable here to power
the unit from an AC wall outlet.
How to connect the input terminals to
input devices such as a control amplifier
Connect between the output terminals of an input device
such as a control amplifier and the input terminals of this unit
with pin-plug cables or balanced cables.
Take extra care not to incorrectly connect between right and
left channels. If the right and left channels are connected
reversely, the localization of sound images will deteriorate,
thus failing in normal stereo playback.
If pin-plug cables are used, inadequate connection of the
grounding of the cables may generate noise including a hum,
resulting in an adverse S/N ratio. Carefully insert the connec-
tion plug correctly.
How to connect between the trigger input
terminal and other devices
A control amplifier such as a C-900u and a power ampli-
fier such as an M-10X can be connected. This connection
enables this unit to turn to operation/standby in conjunction
with the connected device.
Use the supplied modular conversion cable to connect a
device with a modular output terminal such as a C-900u; use
a commercially available 3.5 mm monaural mini-plug cable
to connect a device with a 3.5 mm output terminal such as
an M-10X.
When connection is conducted from a product made by
other than LUXMAN, make sure that the trigger output is
12V. When the trigger input of this unit is 12 volts, the power
consumption is 13 mA.
How to connect between the trigger output
terminal and other devices
Use a commercially available 3.5 mm monaural mini-plug
cable to connect to a device with a trigger input terminal such
as an M-10X. This connection enables the connected device
to turn to operation/standby in conjunction with this unit.
The maximum output current that can be supplied from this
unit with 12 V is 100 mA. Be aware that a malfunction may
be caused if a load more than the above is applied to this
unit by connecting such a device or causing a short circuit.