26
How to use Remote Control
Remote control
The remote control shall be aimed at the remote sensor of
this unit within the specified angle range shown in the illus-
tration when used.
Dry cell
[How to load dry cells]
1. Remove the battery cover on the rear of the remote control.
Put your finger on the battery cover claw and slide the cover
downward to remove the cover.
2. Put 2 AAA batteries in the battery case as shown in the illus-
tration on the battery case in consideration of the polarity (⊕
and ⊖).
3. In the reverse order of battery cover removal, put the battery
cover back to the opening of the remote control and slide the
cover upward until it clicks.
* When the batteries start to lose power, the effective dis-
tance becomes shorter or the unit does not function even
though the switch is pressed.
In such a case, both of the batteries shall be replaced with
new ones at the same time.
* If the remote control is not used for a long time, the batter-
ies shall be removed from the case.
Claw
30°30°
To Next Page
Loading...
Need help?
General
