63
4) Set [LM PRINT] on.
5) Set [RS232 PROTOCOL (COM2)] on.
6) Set [BPS (COM2)] for target LM.
7) Select [LM] for [MODE (COM2)]
5. PRINT (printing setting)
- AUTO PRINT (Off/On): When measurement takes place in automatic measurement mode,
measurement result is printed automatically when the measurement is completed in sequence for the
left and right eyes.
- REF. PRINT (Off/Std/Avg): Built-in printer output form for the Refractometry measurement result
Off: Did not get output.
Std: Outputs only the most recent 10 measurement results and average values.
Avg: Outputs only the average value.
- KER. PRINT (Off/Std/Avg): Built-in printer output form for Keratometry measurement result
Off: Did not get output
Std: Outputs only the most recent 10 measurement results and average values.
Avg: Outputs only the average value.
- EYE IMAGE (Off/On): Selects output of the eyeball and curve figures following REF measurement
result
Off: Did not get output
On: Selects output of the eyeball and curve figures following Refractometry measurement result
- PRINT MESSAGE: Inputs message to be output along with measurement data at the
time of printing. Can input the contents up to two lines. (Refer to “9.6. Input method” )
- R. CYL (Off/On): Selects remaining astigmatism output.
- DISPLAY (YMD/MDY/DMY): year/month/day marking form setting
YMD: year/month/day
MDY: month/day/year
DMY: day/month/year
To Next Page
Loading...