LXNAV Flarm Bat - Default Chapter; Table of Contents; Running Flarm Firmware Update from SD-Card

FlarmBat display Version 1.1 October 2018
Page 2 of 30
1 Important Notices 4
1.1 Limited Warranty 4
1.2 Battery information 5
1.2.1 Disposal of Old Electrical & Electronic Equipment 5
1.2.2 Disposal of waste batteries 6
2 Packing Lists 7
3 Basics 8
3.1 LXNAV FlarmBat display at a Glance 8
3.1.1 LXNAV FlarmBat features 9
3.1.2 Interfaces 9
3.1.3 Technical Data 9
3.2 Hardware variants 9
3.2.1 PowerFlarm module 9
3.2.2 Secondary PowerFlarm module 9
3.2.3 ADS-B module 10
4 System Description 11
4.1 Description of Flarm (PowerFlarm) Led Display 11
4.1.1 Status LEDs 11
4.1.2 Battery and charger status LEDs 11
4.1.3 Horizontal direction LEDs 11
4.1.4 Vertical direction LEDs 12
4.1.5 7 segment LED distance to the target indicator 12
4.1.6 SD card socket 12
4.1.7 Push Button 12
4.1.8 ALS 12
4.2 Powering up FlarmBat 12
4.3 Startup sequence 13
4.4 Shutting down FlarmBat 13
4.5 Normal operation 13
4.5.1 WARNING Modes: 13
4.5.2 NEAREST Mode: 13
4.5.2.1 Multi target in nearest modus 13
4.5.3 Obstacle warning 14
4.5.4 Undirected PCAS warning 14
4.6 Setting up FlarmBat 15
4.7 Other indications 16
4.7.1 IGC-file download onto SD-card (1) 17
4.7.2 Running Flarm firmware update from SD-card (2) 17
4.7.3 Obstacle database update from SD-card (3) 17
4.7.4 Diagnostic dump (4) 17
4.7.5 Restore file system (5) 17
4.7.6 Internal consistency check (6) 18
4.7.7 Error codes from flarm 18
4.8 Wiring 20
4.8.1 FlarmBat pinout 20
4.8.1.1 FlarmBat – FlarmView 21
4.8.1.2 FlarmBat – FlarmLED 21
4.8.1.3 FlarmBat – FlarmLED – Oudie 21
4.8.1.4 FlarmBat – FlarmView – Sxxx Vario 22
4.8.1.5 FlarmBat – LX9xxx – FlarmView 22
4.9 Firmware update 23