BASIC PROCEDURES
520001663-013_b
Start engine as per usual m anual starting.
WARNING
When starting t he snowmob ile in an emergency situation ,
using driv e pulley, do not reinstall the belt guard and return
slowly to h ave snowmobile repaired.
Vehicle Warm-Up
Before every ride, vehicle has to be warmed up as follows.
1. Start engine as explained in
ENGINE STARTING PROCEDURE
above.
2. Allow engine to warm up one or two minutes at idle speed.
NOTE: Engine will shut down after approximately 12 minutes of
idling.
3. Disengage parking brake.
4. Apply throttle until drive pulley engages. D rive at low speed the
first two or three m inutes.
134
_________________
To Next Page
Loading...
Need help?
General
