RIDING THE VEHICLE
4. Check fuel and injection oil for levels and leaks. Replenish if nec-
essary and in case of any leaks; you should seek service from an
authorized Lynx dealer, repair shop, or person of your own choos-
ing fo r maintenance, repair, or replacement.
5. All storage compartmen ts must be properly latched and they
must not contain any heavy or b reakable objects. Ho od and side
panels must be also properly latched.
6. Activate the throttle control lever several times to check that it op-
erates easily an d smoothly. It must return to idle position when
released.
7. Activate the brake lever and make sure the brake fully applies be-
fore the brake control lever touches the handlebar grip. It must
fully return when released.
8. Apply parking brake and check if it operates properly. Leave park-
ing brake applied.
9. Inspect drive belt condition and height, refer to
DRIVE BELT
in
MAINTENANCE PROCEDURES
.
After Engine is Started
For proper engine starting procedure, refer to the appropriate
EN-
GINE STARTING PROCEDURE
.
1. Check headlights high beam and low beam, taillight, stop light
and pilot lamps operation.
NOTE: You may need to detach tether cord from your clothes to
check lights. In such a case, attach cord as soon as you get back at
the controls of the snowmobile.
2. Check the engine cut-off switch (by pulling tether cord cap) and
emergency en gine stop switch operation.
3. Release parking brake.
4. Refer to
VEHICLE WARM UP
and follow instructions.
20
____
SAFETY INFORMATION
____
To Next Page
Loading...
Need help?
General
