Lynx S-60 User Manual

Step 7
• Insert the roll holder support with the screws into the holes of the stand then tighten them as Figure 2-6.
You can choose roll holder support’s position by inserting into different holes.
Figure 2-7
Step 8
• Place two roll holders into the holes in the roll holder support (Figure 2-8). The nuts at the end of the
roll holders will need to be unscrewed to install them.
2. Installation 2-5
Figure 2-8

Lynx S-60 Specifications

General

Brand	Lynx
Model	S-60
Category	Cutter
Language	English