2. Installation
2.1 Installation
Caution 1
• Make sure the power switch is off before installing the cutting plotter.
• Carefully handle the cutter to prevent any injuries.
Caution 2 Choosing a proper place before setting up the cutting plotter
Before installing your cutting plotter, select a suitable location, which meets the following conditions.
• The machine can be approached easily from any direction.
• Keep enough space for the machine, accessories and supplies.
• Keep the working area stable, avoiding severe vibration.
• Keep the temperature between 41
o
-104
o
F in the workshop. (High temperature may damage vinyl).
• Keep the relative humidity between 30% and 70% in the workshop.
• Protects the machine from dust and strong air current.
• Do not place machine in direct sunlight.
Caution 3 Connecting the Power Supply
Check the plug of the power cord to see if it mates with the wall outlet. If not, please contact your dealer.
• Insert the plug (male) into a grounded power outlet.
• Insert the other end (female) of power cord into the AC connector of the cutting plotter.
2. Installation 2-1
To Next Page
Loading...