6. Trouble Shooting
This chapter helps you to correct some common problems you may come across. Prior to getting into the details
of this chapter, please be sure that your application environment is compatible with the cutting plotter.
Note:
Before having your cutting plotter serviced, please make certain
that the malfunction is in your cutting plotter, not the result of an
interface problem or a malfunction in your computer or a software
problem.
Why is the cutting plotter not functioning?
6.1 If the cutter does not operate?
If your Lynx doesn’t run, please check the following items fi rst:
Is the AC power cord plugged in properly?
Is the AC power cord connected to the power connector properly?
Is the power on?
Solutions:
If the POWER LED lights on, the cutting plotter should be in a normal condition. Switch off the cutting plotter
and turn it on again to see if the problem still exists.
If the POWER LED doesn’t light, contact the technician from your dealer.
6. Troubleshooting 6-1
To Next Page
Loading...