Warning 3 Lever up or no media
Check the lever position and be sure to put the media in the cutting plotter before cutting.
Warning 4 Cannot repeat cutting
This condition happens for two reasons: the buffer holds no data or the buffer is full. For the former condition,
please send a new graph from the computer; for the latter condition, please repeat the same cutting job from the
computer. In both conditions, press ON/OFF LINE key to clear the message.
Warning 5 Communication error
Check if the connection cable is connected to the cutting plotter and computer properly. If yes, then check if the
interface setting is correct, make sure your PC has the same communication protocol as the cutter – 9600 bps, no
parity, 8 bits, 1 stop bit, and none for hand shaking. If you have done the above, try the communication between
your cutting plotter and computer again. Press ON/OFF Line key to force the cutter to on line condition.
Warning 6 Width sensor error
Check if the pinch rollers are positioned above the grid drum and reload the media again.
6. Troubleshooting 6-3
To Next Page
Loading...