8102 secivreSM2M © 8
Antenna
The standard antenna provided with the control panel, must be mounted inside the panel.
The antenna is supplied with SMA connector, that allows easy connection to the panel. The antenna
should be position perpendicular to the ground. Try to keep the antenna away from sources of RF
interference or where metal objects can shield it or otherwise block the cellular radio RF signal.
WARNING : The internal antenna used with this product must be installed to provide separation distan
ce
of at least 7.8 in (20cm) from all persons and must not be co-located or operating in conjunction with any
other antenna or transmitter except in accordance with FCC multi-transmitter product procedure.
NOTE: Antenna problems are rare unless the premises are in an area with poor network coverage, in a
building below ground, or in a metal structure.
Do not use the unit with a damaged antenna. Have your antenna replaced immediately. Use only a
manufacturer approved antenna. Non-approved antennas or modications could impair service quality,
damage the device and violate FCC regulations.
Keypad
Mount the keypad where it is accessible, in a dry and secure location. Perform the following steps to
mount the keypad:
• Remove the keypad front plate by inserting a screwdriver into the slots located on the top of the
keypad.
• Remove the keypad backplate by inserting a screwdriver into the slots located near the bottom of
the back plate and prying up to remove the backplate.
• Secure the keypad backplate to the wall in the desired location. Lift the keypad door. Use all
screw pr
ovided. Use the plastic anchors supplied if the unit is to be mounted on drywall.
• To use the keypad tamper, insert the supplied tamper to the wall with a screw.
• For tamper use, the backplate should be mounted on a smooth, at surface. If mounting is on
rough surface, fasten the enclosed surface tape to the wall to eve out the surface area where the
tamper will be positioned.
• Before attaching the keypad to its backplate, complete the keypad wiring as described in the next
section.
Backup Battery
In the event of an AC power loss, the system is supplied with backup battery that is supervised for
connection and low voltage conditions. This information is available to the monitoring station and the
M2M platform.
NOTE: On a typical installation the battery will last for at least 24 hours.
To Next Page
Loading...
Need help?
General