59
preparation before operation
• If the air conditioner uses R410A refrigerant, make sure to charge
it in liquid state, otherwise, chemical composition of refrigerant
(R410A) inside the system may change affecting the performance
of the air conditioner.
• According to the characteristics of refrigerant (R410A, the value of
GWP is 2088), the pressure of the tube is very high, so be careful
when installing and repairing the appliance.
• The temperature of refrigerant circuit will be high, keep the inter-
connection cables away from copper piping.
before using the air conditioner
Before using the air conditioner, be sure to check and preset the fol-
lowing:
• Remote control. After replacing the remote control batteries with
new ones or when it is energized, the remote control auto preset
the heat pump. If the air conditioner model you acquired is a cool-
ing only model, the heat pump remote control can be used.
• Backlight function of remote control (on some models).
Hold down any button on remote control to activate the backlight.
It automatically shuts off after 10 seconds.
• Auto Restart. The air conditioner is equipped with an Auto-Re-
start function.
protect the environment
This appliance is made of recyclable or reusable material. Scrapping
must be carried out in compliance with local waste disposal regula-
tions, Before scrapping it, make sure to cut off the mains cord so
that the appliance cannot be reused.
For more detailed information on handling and recycling this prod-
uct, contact your local authorities who deal with the separate collec-
tion of rubbish or the shop where you bought the appliance.
This appliance is marked according to the European Directive 2012/
19/EC, Waste Electrical and Electronic Equipment (WEEE).
To Next Page
Loading...
Need help?
General
