How to remove short circuit block on MAC Inverter?
To remove the blocked status on your MAC Inverter, set the number of short circuits to zero in parameter 65, labeled “Total de cortocircuitos detectados”. If the problem persists, try restarting the EPOWER by disconnecting the pump.
How to fix ID Error on MAC Inverter?
To eliminate the error on your MAC Inverter, you need to change parameter 4 "Config. Red ID" in the advanced menu and assign the inverter a new numeric value between 0 and 7.
What to do if MAC E-Power e-MM/MT displays 'Water Hammer'?
If your MAC Inverter displays 'Golpe de ariete. Water Hammer', it means the system has detected an overpressure greater than 2 times the working pressure. Verify the correct sizing of the pre-charged tank.
Guidance on selecting the appropriate pump for optimal EPOWER performance.
Steps for connecting the EPOWER to the hydraulic system.
Steps for connecting the EPOWER to the electrical supply.
Details automatic protection mechanisms and reset procedures.
Details error codes, fault meanings, and required actions for maintenance.
General| Category | Inverter |
|---|---|
| Model | e-MM/MT |
| Input Voltage | 12VDC / 24VDC / 48VDC / 110VDC / 220VDC |
| Output Voltage | 110VAC / 220VAC / 230VAC |
| Frequency | 50Hz / 60Hz |
| Protection Features | Overload, short circuit, over voltage, low voltage, over temperature |
To Next Page