MCSP40 by MacAllister
Before you start
Getting started...
GB
IE
14
Chain lubrication
NOTE: Always dispose of lubricant, used oil and objects
contaminated with them in accordance with local
regulations.
NOTE: This product is equipped with an automatic oiling
system! The oiling system automatically delivers the
proper amount of oil to the bar and chain!
Checking the lubrication requires starting the engine.
Before checking the product must be fully assembled and
all instructions must have been read.
Checking
Check the chain lubrication before each use. >
Make sure the guide bar (4) and >
the saw chain (3) are in place
when you check the oil delivery.
Start the engine; keep it running >
at medium power and check if the
chain oil is delivered as shown in
the gure (Fig. 18).
Fig. 18
Adjust the chain oil ow using >
screwdriver (34) on the adjuster
screw (Fig. 19, a) of the oiler,
which is on the bottom of the
product.
34
a
To Next Page
Loading...
